How we seal and insulate your property
A straightforward, four-stage process designed to eliminate drafts, lower heating bills, and keep your home or commercial building comfortable year-round.
Reach out by phone or send your project details through our online quote form. We discuss your property layout, primary comfort or draft concerns, and arrange a convenient on-site visit.
Our technician visits your property in Hamilton or neighboring communities. We measure target cavities, check ventilation and substrate moisture, and give you a firm written quote.
Our certified crew preps and masks all adjacent living zones, confirms ambient temperature and substrate readiness, and applies closed-cell or open-cell foam using dedicated fresh-air ventilation.
We run a detailed final inspection, remove all masking materials, and clean the space thoroughly. You immediately notice warmer floors, fewer drafts, balanced temperatures, and lower energy waste.
Ready to assess your insulation project?
Book a free site inspection in Hamilton, Burlington, Brantford, Niagara, or surrounding communities.
What to expect on installation day
Professional spray foam installation requires disciplined air management, tight structural prep, and zero shortcuts. Here is how our certified technicians protect your property from setup through the final cure.
Arrival window and initial site walk
Our crew arrives within your confirmed morning window. We walk the perimeter with you to verify attic or basement access, review safety lines, and confirm utilities.
Surface masking and overspray shielding
We lay heavy-duty floor runners along every travel route. Windows, doors, trim, and mechanical equipment are sealed with airtight polyethylene sheeting.
Negative-air exhaust extraction
High-volume extraction blowers vent work zone air directly outdoors, creating negative atmospheric pressure to prevent chemical vapor migration into living areas.
Building clearance and mandatory curing
Occupants and pets remain off-site during the active spray cycle and for the standard 24-hour curing window to ensure zero lingering volatile compounds.
Mandatory Jobsite Standards
CUFCA CertifiedRig Protocol
Closed-cell and open-cell formulas mixed on-site inside our temperature-controlled mobile rig.
Need to schedule project prep?
Our technicians provide an exact pre-arrival checklist 48 hours before installation so your space is prepped smoothly.
Ready to get started?
Schedule your free on-site estimate today. We assess your space, explain the insulation options, and provide a clear, fixed quote with no surprises.
Your home's comfort starts from the core
Professional spray foam insulation contractor serving Hamilton, Ancaster, Burlington, Niagara, and surrounding communities.
Contact
- Direct Line289 588 CORE (2673)
- Emailinfo@Spraycor.ca
- HeadquartersMount Hope, Ontario
Navigation
© 2026 SprayCOR. All rights reserved.